Please Wait...



Divider Icon Image

Various Necessary Tests

Load Test, Length & Width Test etc. are also carried out.

Denier Checking

Beta gauge machines which continuously checks the size and the denier of the tape.

Fabric Checking

Fabric produced by every loom is checked for right weaving, width and strength

Tensile Test

Tensile and breaking strength of all the lots is checked on Tensile Tester.

“Trust is good but verification is always better”

Blending Ratios

              Manager Production conveys the ratio of blending to the Plant Manager; who ensures that; blending of virgin raw material, fillers, master batches, stabilizers are blended according to the order specific requirements; to obtain desired results.

Tape Plant

              We have defined Quality Control Systems which ensures; that the Strength, GSM, GPD properties are met, according to the order’s requirement. Plant Manager closely monitor and initiate immediate actions; accordingly to achieve the accuracy in end product of Tape Plant; i.e. tapes.

               Tapes extracted out of Tape Plant are closely monitored twice per lot; for essential strength, denier, tape-width, elongation at break and breaking loads. Results are monitored by Tape Plant Manager. Samples are drawn every hour and the cycle of analysis moves in the same fashion in both the shifts. Up-to-date records are maintained up to dispatch to ensure traceability of lots.

               On very rare occasions; if deviations from set specifications are observed winders are advised to stock the non-confirming tapes; separately; whilst the corrective action is immediately taken. Such non-conforming materials are used to prepare wrapping fabric or substitute usage.

Bag Cutting and Stitching

              Un-laminated / Laminated rolls / Un-Printed / Printed rolls (according to requirements specified) are then forwarded to the Bag Cutting and Stitching process; wherein they are being cut into required sizes; bottom stitched; and then forwarded to Hemming Section; if required. Finishing Dept. Supervisor randomly checks output of all the machines for number of stitches, correct fold and size of stitched bags; once the lot is started and repeatedly whiles it’s manufactured; least twice a day.

               At M-Square Polypack, the end product passes through Some quality check phrases; as a result of which the quality is superior & significantly consistent. All incoming raw materials are verified; for their respective grades and quality parameters so that we could deliver better results after manufacturing.

               Our quality checking phrases; start from the very early stages of the fabric / sacks manufacturing; since blending of raw materials. We monitor and conduct repeated analysis necessary to ascertain that; the consistency as per requirement of GSM; is met; so that the tapes; extracted out of it; gives best results on the looms.